Split & ducted systems

Air conditioning installation in Sydney

Split systems and ducted air conditioning, supplied, installed and commissioned — with the electrical side handled by the same team.

Burning smell, sparking switchboard or no power?

Do not touch it. Call us — 24 hours, every day.

Call 0434 757 074 now
Overview

Air conditioning done once, done properly.

Air conditioning is where the trades usually split: one company hangs the unit, another turns up later to sort the power out. We do both, which matters because the electrical side is what decides whether the system can be installed at all.

A ducted system or a large split can push a house past what its switchboard or consumer mains can carry. We check that before you buy equipment, not after.

Systems

Split & ducted

Typical duration

1 day, single split

Includes

Dedicated circuit

Paperwork

Compliance certificate

What is included

Everything in the price, listed.

Load and sizing assessment

Room size, orientation, insulation and glazing, so the unit is not under or over specified.

Supply and install

Split systems and ducted systems, indoor and outdoor units.

Dedicated circuit

New circuit run from the board, correctly rated and protected.

Switchboard capacity

Space, protection and mains capacity checked and upgraded where required.

Pipework and drainage

Refrigerant lines and condensate run correctly so it does not leak into a ceiling.

Commissioning

System charged, tested, and controls explained before we leave.

Before you book

What determines the price

  • Capacity in kilowatts, and whether the room really needs that much
  • Distance between indoor and outdoor units
  • Whether a dedicated circuit already exists at the board
  • Whether the switchboard has space and RCD protection
  • Single or three phase supply for larger ducted systems
  • Access — roof space, wall type, and where the outdoor unit lands
Detail

The electrical half of the job

Every fixed air conditioner needs its own circuit. On a full switchboard that means either a board upgrade or, on older homes, an upgrade to the consumer mains as well before anything gets installed.

Because we are accredited for network-side work, a mains upgrade does not become a second job with a second contractor and a second wait.

  • Site assessed for capacity, placement and electrical supply
  • Board and mains checked before equipment is ordered
  • Units mounted, piped, drained and wired
  • System evacuated, charged and commissioned
  • Controls demonstrated and compliance paperwork issued

24/7

Emergency callout

2

Networks accredited

$0

To quote your job

401213C

NSW licence

How a job runs

Four steps, no mystery.

You call or send the form

Tell us what's happening. If it's dangerous we tell you what to switch off.

We quote it in writing

Fixed price where we can, hourly where the fault is unknown.

We do the work

On the agreed day. Anything that changes the price gets your approval first.

You get the paperwork

Certificate of Compliance, plus any network notification we lodged.

Straight answers

Air conditioning questions we get asked.

Do you supply the unit or do I?

Either. We can supply and install, or install a unit you have already bought — tell us the model when you ask for a quote.

Will my switchboard cope?

Often yes for a single split, less often for ducted. We check the board and the mains as part of quoting.

Do I need three phase for ducted?

Larger ducted systems sometimes do. If yours does, we can handle the supply upgrade as accredited work.

Who does the refrigerant work?

Licensed refrigerant handling is required for the pipework and charging, and that is part of the install.

Can you replace an old system?

Yes, including removing and disposing of the old unit and reusing existing pipework where it is suitable.

Get a written quote before anything starts.

Free quotes, 24/7 emergency, and a real person on the phone.